HT4623 my iphone wont come on but showing to plug into itunes
my iphone 4s for some reason is not coming on on charge yet keeps showing me the itunes signal. can any1 tell me why it wont come on or why its saying itunes thanks
http://support.apple.com/kb/HT1808
Similar Messages
-
my iphone wont turn on but when i plug it in to charge the apple logo comes on and turns back off after a few seconds i dont know what to do i need help
Hello warhogs17,
After reviewing your post, it sounds like the iPhone will not turn on past the Apple logo. I would recommend that you read this article, it may be able to help the issue.
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support
Thanks for using Apple Support Communities.
Have a nice day,
Mario -
My ios update keeps getting stuck on the Restoring iPhone software stage. I uninstalled iTunes and reinstalled it again, but still nothing. Now I can't even use my phone as it shows the plug into iTunes screen. Please help!!!! Thanks,
A Restore first downloads a new copy of iOS to your computer. On a slow Internet connection this can take a long time. How fast is your connection? How long would you expect it to take to download 900 MB?
That's assuming nothing is interfering with the download. Some firewalls and antivirus programs will block the download or slow it down. So you should temporarily disable your security software. Security software can also block the update after the iOS download is complete. -
My phone is telling me to restore it as it will not come on and just shows a plug into itunes sign...however there is an error restoring it. HELP?!
You might try:
Placing your device into recovery (DFU) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
until the red slider appears, then slide the slider. Wait for the device to turn off.
* If you cannot turn off the device using the slider, press and hold the
Sleep/Wake and Home buttons at the same time. When the device turns off,
release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
device. The device should turn on. Note: If you see the battery charge warning,
let the device charge for at least ten minutes to ensure that the battery has some
charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
On my iphone 4 it shows to plug into itunes
on my iphone 4 it shows to plug into itunes but does not restore anyone
Unable to Update or Restore..?
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps.. -
my little sisters ipad mini is disabled, it does not say anything but that no plug into itunes or countdown, however it is connected to my mums iphone apple account, she can not lose anything as its for work, how can i fix this???
Follow these instructions to resolve a forgotten passcode:
http://support.apple.com/kb/HT1212 -
found olf iphone 4 or 4s in the back of my parents closet. They told me I could now have it back and its been a year since the last time I saw it. It wont turn on unless it is plugged up to a wall plug in. But as soon as I turn it on it says activation required then it says plug into itunes. After I try doing that it plugs into my computer but flashes the apple logo on and off. It wont even turn on all the way when plugged into computer...only the wall. ANY IDEAS?): and no I didnt steal/find this phone. It is mine. I dont have the guts to steal but a lot of people online have accused me.
You may need to force it into recovery mode. See here: https://discussions.apple.com/message/17766427#17766427
-
I connect my iphone 4 to the itune. It asked me to download a new update for my phone. After I downloaded the update, the itune no longer able to detect my iphone through the USB. My phone is un-responsive showing the plug into the itune icon only on the screen. Please help.
http://support.apple.com/kb/HT1808
-
how can i get my ph usage back? Its locked up in the "plug into itunes" screen & wont let me get out. telling me on itunes that its going to restore to factory setting. I dont want to lose my new pics etc... so how do i back out of this so i can double chk my icoud back up?
If you are trying to say that when you connect to iTunes on your computer your Device is not appearing.... Then...
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
Be sure to Follow ALL the Steps...
After the successful Recovery...
Restore from Backup
http://support.apple.com/kb/ht1766 -
IPhone 4 wont boot up and stuck in Plug into ITunes
Hey Can u Guys plz help me my iphone 4 wont boot up it is stuck in Plug Into ITunes logo. when i tryed to restore it I get error message (1) so i have tryed to do it In DFU mode and still no luck so can anyone of you people help me and also i have tryed to do it on 4 computers and still get the same thing i dont know what to do it almost seems like there is no firmware on the iphone it wont go out of recovery mode and also when i was updateing the iphone to ios 4.3.5 in the middle of the install like when the phone was at the apple logo and the loading bar at half way i got the error message (1) and after that i could not boot it up. help Would be really appreciated.
hold down the on/off button and then square button at the same time, then once the phone turns off, turn it back on and plug it into your computer... this is what I did and my phone is now on...however; it says it is in recovery mode and i need to restore it to its original settings
-
Have iphone 3g with 5.0 I downloaded 5.01 for phone and itunes latest download. Had errors on download and needed to restore. Everything came back except apps.
Pluged into itunes and it gave me the restore screen. restored again. Now when i plug into itunes it shows my phone but freezes up. I need to use task master to close itunes. Went to apple store tech. No help said to use Icloud but no WiFi is available. My wife's phone works fine with itunes.Basic troubleshooting steps clearly outlined in the User Guide are restart, reset, restore from backup, restore as new device.
If you have gone through ALL the above steps and are still having problems, then you'll need to bring your phone into Apple for evaluation. -
My iPhone 5s is stuck in reboot and plug into iTunes
I tried to update my software version using iTunes. I got a #17 error. I tried rebooting my iPhone after unplugging it from my PC. No I am stuck in some type of loop where I get the Apple icon when I turn on the phone and it turns into the "plug into iTunes" symbol shortly after. When I plug it back into my PC and connect to iTunes it tells my I must restore my phone to original settings. When I opt for that it get the error 17 again. Any ideas? Thanks.
Hi, that is call Recovery Mode. You can try Dr.Fone for iOS to get it out of the Recovery mode:
Step 1. download and install the trial version of Dr.Fone on your computer;
Step 2. Connect your iPhone with your computer via its USB cable;
Step 3. On your iPhone, click 'Trust'. Launch Dr.Fone for iOS and click the 'Restart the device' to start your iPhone. -
Good Day iPhone saviors: My iPhone 4s screen is stuck, only showing the plug & iTunes symbol
Hi Tim Schneck,
Thanks for visiting Apple Support Communities.
If you're only seeing the "Connect to iTunes" screen on your iPhone, the device is in recovery mode and may need to be restored.
For more information, see this page on our support site:
If you can't update or restore your iPhone, iPad, or iPod touch
Best Regards,
Jeremy -
Tried to update my iphone 4 and got an error message. Now I can't update my phone or even restore it!!
Hi phaniemae528,
If you are having issues updating or restoring your iPhone, you may find the following article helpful:
Apple Support: If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Regards,
- Brenden -
I don't know what to do with my ipad2?
I'm guessing you did not buy the iPad from Apple. If you did not buy it from Apple, it may very well have an older software version. Only iOS 5 or later is PC independent. If you have an earlier version, a computer with iTunes loaded is required.
Merry Christmas
Maybe you are looking for
-
The name "XYZ" does not exist in the namespace
I was getting error "The name "XYZ" does not exist in the namespace " at here <UserControl.Resources> <ms:VisiableConverter x:Key="VisiableConverter"></ms:VisiableConverter> </UserControl.Resources> How to solve? namespace DictionaryApp.Model public
-
Oracle8i personal edition Autorun trouble
I am having trouble installing 8i personal edition on windows 98. I keep on getting a message when I click on Install/deinstall programs when running the autorun program. The message says "Unable to start Oracle installer. Please verify the path for
-
BW Document Integration - Upload of Texts from R/3
Hello, I have a scenario where I need to maintain small 'notepads' (250 to 500 chars) related to specific values of an infoobject (Business Partner). I see two solutions: A) 1) Maintain texts in the R/3 master data maintenance of the corresponding ob
-
HIDE ORDER AS DIRECT MATERIAL checkbox for material item in Shopping cart
HI, We are on SRM 7.1 ECS. I need to hide the ORDER AS DIRECT MATERIAL checkbox under the ITEM DATA tab in the Shopping cart screen...How do I do it??Is there any config option or I need to implement a badi in SRM 7?
-
I have just installed CS3 Bridge on my Windows PC system. I already have Photoshop CS2 and Bridge CS2 installed. How can I tell if I have the latest version of Camera Raw installed in CS3 Bridge and Photoshop CS2? This is not helpful: "How do I know